The Specs, Straight Up
Here’s the deal: we built this heater for industrial machines that simply can’t risk a meltdown. One wrong move, and the whole thing shouldn’t go up in flames. It runs on 400V and cranks out 2500W of power. That’s a lot of heat packed into a small space, which is exactly what you need when space is tight. The 300mm tube length is intentional. It puts the heat right where you need it, so you don’t have to tear apart your whole machine just to make it fit. It gets parts hot, fast. But, because of that power, you’ve got to make sure your machine’s cooling and wiring are up to the task. No cutting corners.
What’s Inside Matters
Inside, you’ve got a shortwave halogen element sitting in a quartz tube. The halogen cycle keeps the filament stable, so the heat stays steady, even after hours of running. The tube itself is coated to take a beating. It’s built to shrug off shocks and the grime that’s just part of life on the shop floor. And the R7s connector? That’s for easy swaps. It slides right into standard fixtures, giving you a solid connection—both mechanically and electrically—without a headache. Plus, there’s a tip-over switch hardwired in. If the heater gets knocked out of place, the circuit cuts off immediately. No fuss. No danger.
Where It Shines
This setup shines when you need the same results, over and over again—like in PET blowing or other heating steps where consistency is everything. The intense, focused heat means you’re not waiting around. And that safety switch gives you peace of mind, knowing that if the unit gets bumped, it won’t overheat and cause trouble. It’s a tough heater. It can take the hits. And when it’s time for maintenance, that connector makes it a breeze. Just remember: with 2500W on tap, your control system and cooling have to be on the same level. Plan for it, and this thing will run like a dream.